Analog and Digital Intertie

Remote Control for Water Systems

Analog Output Remote Control

Use your web portal to adjust remote chemical doser pumps or variable speed drives with analog output options. Automate your analog output requirements with analog-intertie. Tech support can match your source analog channel with a destination analog output channel.

Digital (Output Relay) Remote Control

Use your web portal to remotely control a by-pass pump or reset a locked up programmable logic controller (PLC) with M800 series RTUs and their on-board output relays. Automatically control remote pumps or valves with Digital-Intertie.  Technical support can mate a digital input as the source to the output relay of a destination RTU. We can also reverse the polarity so that an open signal at the source causes a close signal at the destination and vice versa.

Remote Control
Mission offers several remote-control options that can be manually initiated from the web portal or automatically operated in some cases.
  • Make a temporary failure nearly transparent
  • Gain a timely warning of an extended failure

What You Will Need:

Analog Output
  • Add two 4–20mA analog output channels to the M800 remote terminal unit (RTU) by way of (PN OP 460).
  • Add two channels as either 4–20mA or 0–5V to the MyDro 850 RTU with (PN OP461).
Digital Output
  • The RTU at the destination must be an M800 or MyDro 850.
  • The source can be a digital alarm input from any RTU, including the Manhole Monitor, or any digital input (including runtime) of an M800 or MyDro 850.
  • The output relays feature both normally-open and normally-closed contacts for fail-safe considerations.

You’re Never Alone

You will receive experienced technical support, including access to the people that built the system if needed. This includes comprehensive training, regular webinars, live support during business hours and after-hours support that is always available on a responsive callback basis for emergencies—at no extra charge.